Connecting Cables
- The fiber connector connected to the optical port on the wall varies depending on actual conditions.
- To ensure normal use of fibers, make sure that the fiber bending radius is larger than 30 mm.
|
No. |
Item |
Description |
|---|---|---|
|
1 |
On/Off |
Powers the ONT on or off. |
|
2 |
Power |
Connects to a power adapter. |
|
3 |
LAN1-LAN4 |
Connects to PCs or IP set-top boxes (STBs). |
|
4 |
Reset |
Press the button for a short time to reset the device; or press the button for a long time (longer than 10s) to restore the device to the default settings and reset the device. NOTE:
Reset Huawei ONTs with caution. Otherwise, the ONTs may fail to access the Internet. If an ONT cannot access the Internet after a reset, contact your Internet service provider. |
|
5 |
WLAN |
Used to enable or disable the WLAN function. - When the WLAN is disabled, press the WLAN button (> 3s) and release the button to enable the WLAN. - When the WLAN is enabled, press the WLAN button (> 3s) and release the button to disable the WLAN. |
|
6 |
WPS |
When the WLAN is on, press the WPS button (> 3s) and release the button to start Wi-Fi protected setup (WPS) negotiation. |
|
7 |
Optical port |
The optical port is equipped with a rubber plug and connected to a fiber for upstream transmission. The type of the optical connector connected to the optical port can be SC/APC. |
Comments
0 comments
Article is closed for comments.